Er. Saras Agarwal, Rajive Gupta

Determination of Optimal Cutting Conditions for Face Milling Operation

Using Dynamic Programming

• Broschiertes Buch

Produktbeschreibung

In a Computer Aided Process Planning (CAPP) system, one of the important module is determination of optimal cutting conditions. In the proposed work, multipass face milling operations, consisting of few rough as well as finish pass have been considered. The production cost per piece has been minimized under practical constraints of cutting force, cutting power, surface finish etc. and limits of cutting speed, feed and depth of cut. The common practice is to use a non linear programming method for finding out optimum cutting conditions for each single pass machining. Instead a simple solution technique has been considered for finding optimum cutting conditions for a single finish as well as a rough pass. Thereafter optimum number of passes, depth of cut, cutting speed and feed for each pass has been obtained. It has been observed that optimal subdivision of total depth of cut, to a good accuracy, is obtained by using simple single pass solution technique and Dynamic programming.

---

Hinweis: Dieser Artikel kann nur an eine deutsche Lieferadresse ausgeliefert werden.

Produktdetails

• Verlag: LAP Lambert Academic Publishing
• Seitenzahl: 92
• Erscheinungstermin: 9. Februar 2022
• Englisch
• Abmessung: 220mm x 150mm x 6mm
• Gewicht: 155g
• ISBN-13: 9786204741628
• ISBN-10: 6204741624
• Artikelnr.: 63486406

Autorenporträt

Er. Saras Agarwal schloss im Jahr 2003 seinen M.Tech am HBTI, Kanpur, ab und absolvierte seinen MBA am XLRI, Jamshedpur. Er arbeitet seit mehr als 10 Jahren bei Tata Technologies.Prof. Rajive Gupta hatte seinen M.Tech am IIT Kanpur gemacht, bevor er zu Maruti Udyog Limited kam. Er arbeitete dort etwa 2 Jahre, bevor er zu HBTI, Kanpur, kam. Er ist als Professor tätig.