Andere Kunden interessierten sich auch für
![Development of a new heat-resistant alloy and technology of parts production]( "Development of a new heat-resistant alloy and technology of parts production")
Development of a new heat-resistant alloy and technology of parts production16,99 €![Numerical simulation of the behaviour of thin parts during milling]( "Numerical simulation of the behaviour of thin parts during milling")
Numerical simulation of the behaviour of thin parts during milling29,99 €![Progressive failure analysis for aeronautic composite structures]( "Progressive failure analysis for aeronautic composite structures")
Progressive failure analysis for aeronautic composite structures45,99 €![Performance Analysis of an Optimized Asymmetric MLI]( "Performance Analysis of an Optimized Asymmetric MLI")
Performance Analysis of an Optimized Asymmetric MLI29,99 €![Development of Al-MMC by reinformcement and its use in automotive parts]( "Development of Al-MMC by reinformcement and its use in automotive parts")
Development of Al-MMC by reinformcement and its use in automotive parts36,99 €![Automatic determination of parting line for die-casting parts]( "Automatic determination of parting line for die-casting parts")
Automatic determination of parting line for die-casting parts23,99 €![Optimized Engineering Vibration Isolation, Absorption and Control]( "Optimized Engineering Vibration Isolation, Absorption and Control")
Optimized Engineering Vibration Isolation, Absorption and Control110,99 €
Topological optimisation makes it possible to design parts in which the material is distributed as efficiently as possible in terms of the loads absorbed. Under the same operating conditions, optimised parts have 20-70% less mass than conventional parts, which is essential in aircraft design. However, in most cases these parts have very complex shapes that cannot be reproduced using the most common technologies. Additive manufacturing facilities for metal powders and consumables are expensive, which can be a deciding factor in the design of a new product.This book discusses a method of producing topologically optimised parts that does not require the use of expensive powder metal sintering or melting additive manufacturing equipment - investment casting of topologically optimised models pre-printed on a 3D printer.