Tensorial Analysis of Networks (Tan) Modelling for PCB Signal Integrity and EMC Analysis

Herausgeber: Ravelo, Blaise; Xu, Zhifei

• Gebundenes Buch

Produktbeschreibung

This book describes a fast, accurate and flexible modelling methodology for PCBs. With its systematic approach to addressing tensorial analysis of networks (TAN) modelling methods, the book provides information and solutions to the designers and manufacturers of analogue, RF, digital and mixed signal electronic circuits and systems.

---

Hinweis: Dieser Artikel kann nur an eine deutsche Lieferadresse ausgeliefert werden.

Produktdetails

• Materials, Circuits and Device
• Verlag: Institution of Engineering & Technology
• Seitenzahl: 400
• Erscheinungstermin: 8. September 2020
• Englisch
• Abmessung: 236mm x 164mm x 25mm
• Gewicht: 791g
• ISBN-13: 9781839530494
• ISBN-10: 1839530499
• Artikelnr.: 59291198

Inhaltsangabe

* Chapter 1: General introduction
* Chapter 2: Basic knowledge to practice TAN for PCB SI/PI/EMC
investigation
* Chapter 3: CB primitive components analysis with TAN
* Chapter 4: Analytical calculation of PCB trace Z/Y/T/S matrices with
TAN approach
* Chapter 5: Fast S-parameter Kron-Branin's modelling of rectangular
wave guide (RWG) structure via mesh impedance reduction
* Chapter 6: Time-domain TAN modelling of PCB-lumped system with Kron's
method
* Chapter 7: Direct time-domain analysis with TAN method for
distributed PCB modelling
* Chapter 8: Coupling between EM field and multilayer PCB with MKME
* Chapter 9: Conducted emissions (CEs) EMC TAN modelling
* Chapter 10: PCB-conducted susceptibility (CS) EMC TAN modelling
* Chapter 11: PCB-radiated susceptibility (RS) EMC TAN modelling
* Chapter 12: TAN model of loop probe coupling onto shielded coaxial
short cable
* Chapter 13: Nonlinear behaviour conduced EMC model of an ADC-based
mixed PCB under radio-frequency interference (RFI)
* Chapter 14: Far-field prediction combining simulations with
near-field measurements for EMI assessment of PCBs
* Chapter 15: Element of information for numerical modelling on PCB:
focus on boundary element method
* Chapter 16: General conclusion